BRIDGE App

Recording/Logging

To begin recording in the BRIDGE App, simply press the on screen record button or the assigned input, to start and then again a second time to end.

All files and data will be saved to the File Destination folder that gets set in the 'Miscellaneous Settings' page.

Snapshots

To take a snapshot in the BRIDGE App, simply press the snapshot button or the assigned input.

Media Gallery

All of your recordings, data logs and snapshots can be accessed through the media gallery as shown below. These files are populated from the 'File destination folder', which can be changed under the 'Other Settings' page. 

The media gallery can be accessed with or without your vehicle connected.

Dive Logs

All recordings will trigger a dive log to be created. These logs will include playback of location data, telemetry and POIs taken.

Dive logs can be accessed with or without your vehicle connected. 

Selecting the POIs tab will allow you to rewatch and review video footage in tandem with location data (if recorded). 

Individual POIs can be viewed on the right hand side and will jump the video playback to when it was recorded.

POI names and notes can be edited or deleted. 

BRIDGE Controller

Recording/Logging

By default, Data Logging can be started and stopped using the right side button on the controller.

Videos will automatically begin a new recording after 30 minutes and save in sequence. This is done to reduce upload and save times.

Data Logging can also be started by clicking Start Logging in the Data Logging menu.

In the data logging menu you will find toggles for each connected/available data source. Select which sources you would like to record.

Once a recording is completed, the files will all be stored within a collected folder on the chosen storage device found in the camera settings page.

Snapshots

By default, the snapshot feature is programmed to the left side button on the controller.

The snapshots will be taken in the corresponding resolution tot he recording type selected in the camera settings menu

File Manager

Opening the file manager in the bridge controller will show all connected storage devices.

The file manager can open and display snapshots only.

Exporting Media saved to the BRIDGE Controller

Files will automatically save to whichever device is selected in the camera settings menu.

When done recording, remove the storage device and transfer to your chosen computer/device. 

Relevant Links

Visit this page if using the onboard recording feature of the 4K UHD camera

Or this page on how to LAN stream from your controller